questjilo.blogg.se - Wahl 5 in 1 blade settings

Wahl 5 in 1 blade settings manual#
Wahl 5 in 1 blade settings full#

Push the blade towards the machine to snap into place.

If this is not the case, you can fold out the clip with a flat screwdriver (Fig.

Attach the new blade set onto the clip (Fig.

Remove the blade set from the clip (Fig.

6a) towards the blade set and lift the blade set away from the housing (Fig.

Switch off the appliance using the on/off switch (Fig.

5) and remove it from the blade set.Ĭhanging the blade set To remove a blade set:

Push the attachment comb towards the cutting edge of the bottom blade (Fig.

4a) and push it over the cutting edge of the bottom blade until it locks (Fig.

Fit the attachment comb onto the bottom edge of the blade set (Fig.

Attachment combs can be used to extend the cutting length range.įor best results we recommend using a #30 or #10 blade with the comb attachments.Īccessories are available from your local dealer. The appliance can also be operated with attachment combs. These can be selected via the on/off switch.

Switch on the appliance using the on/off switch and switch off after use (Fig.

Connect to the mains power supply (Fig.

Model: MAX 45 CORDED DOG CLIPPER – KM6245 / WM6245 ALWAYS apply clipper oil after cleaning with hygienic spray or coolant. If you cut into dirt, immediately clean your blades with Wahl Hygienic Spray or Wahl Clipper Oil to flush out the dirt.

Flushes abrasive particles and hairs out from between the blades.

Wahl 5 in 1 blade settings full#

Provides a low friction, very thin film lubricant between the cutting blades so the blades can take a full cutting stroke without becoming hot from frictional heat.Keeping your blades well oiled performs the following important functions: These particles tend to separate the blades from each other and pull the hair as opposed to cutting it cleanly. Abrasive particles on the animal’s hair, such as dirt, sand, grease, etc will blunt the blades.īlades will not cut if abrasive particles are picked up and carried by the oil film between the blades. The blades are the single most important part of a clipper or trimmer and must be well maintained at all times for maximum cutting performance.Ĭutting hair does not blunt the blades. Always oil your blades before use and before storage to prevent atmospheric moisture causing damage to the blade surface.Whenever storing your appliance, disconnect all cables and store your clipping/trimming kit in a dry, temperate environment.

If your product has an air filter ensure it is clear of obstructions to avoid overheating the motor.Do not separate the top and bottom blade when cleaning. Always clean your machine and blades thoroughly when you have finished clipping.We recommend use of Wahl Hygienic Spray to ensure grease and dirt particles are flushed from the blade surface.During operation, take time to regularly brush hairs and dirt from the blades.Always ensure the animal coat is dry, as clean as possible and brushed to remove tangles, grease and dirt particles from the hair.If blades are getting hot then insufficient oil is being applied or the blades need cleaning or sharpening. Without oil, friction is increased therefore generating heat. Clipper oil lubricates the blades and will ensure your clippers or trimmers perform to their maximum capacity. Regularly apply a few drops of oil to the blades during clipping/trimming.Use this appliance only for its intended purpose.įor maximum efficiency, durability and satisfaction from Wahl clippers and trimmers, please note the following points:.Cleaning and user maintenance shall not be made by children without supervision. Children shall not play with the appliance.

This appliance can be used by children from aged 14 years and above and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.

Wahl 5 in 1 blade settings manual#

Read the instruction manual in full to familiarise yourself with the product before the first use.

When using your electrical appliance, basic safety precautions should always be followed, including the following:

STAINLESS STEEL BLADES AND ATTACHMENT COMBS.

Attaching / removing the attachment comb.